I hear this all the time, but I have never understood it. If I clear my drive cycle monitors, they are all passing again just a few miles later. Do some vehicle manufacturers just put insane constraints on the drive cycle monitors?
> Do some vehicle manufacturers just put insane constraints on the drive cycle monitors?
Yes. Combine with the fact some only pass after certain conditions (eg. over 3000 revs for 10 mins, or idle for 5 mins, or only after 3 starts, only when the outdoor temperature is within this range, etc). Sometimes those conditions aren't stated in the manuals.
That makes the checks passing seem more like a random process and driving more will usually make them pass, eventually.
And drivers without a code reader won't know when it has passed, so they are usually instructed by mechanics to drive a long way to be sure before taking it in for a test (don't want to have to reschedule the test just because you didn't drive it enough).
There is a drive cycle set of requirements and it’s usually possible to clear them in under 20 miles. Trying to figure which part of the cycle isn’t accomplished yet is the challenge. I’ve chased it down on my wife’s Honda when we were trying to get it to go “Ready” the same afternoon. Usually just not doing anything unusual for a day or so of normal use is enough, but you can often query the OBD2 system to get the portion of the cycle that’s not yet complete. Just doing a long highway drive isn’t going to do more than a moderate highway drive already did.
