I've been curious about this for a while- I've got a modest CNC (X-carve) with steppers. If I wanted to upgrade my machine to feedback servos, how simple could it be?
I already have a CNC controller with stepper drivers. Do servos have a stepper interface, and internalize all the servo logic and feedback? IE, can I just buy "servos" that have internal feedback, and send them the same step and dir signals, or SPI signals, needed to drive steppers?
Or, do I have to replace my controller/drivers with a servo-specific driver? The reason I ask is that I have an extremely inexpensive stepper system (grblesp32 6-pack controller with external drivers) and cheap steppers, and definitely am hitting the point where I have to dial back all my parameters to finish cuts without dropping steps.
I already have a CNC controller with stepper drivers. Do servos have a stepper interface, and internalize all the servo logic and feedback? IE, can I just buy "servos" that have internal feedback, and send them the same step and dir signals, or SPI signals, needed to drive steppers?
Or, do I have to replace my controller/drivers with a servo-specific driver? The reason I ask is that I have an extremely inexpensive stepper system (grblesp32 6-pack controller with external drivers) and cheap steppers, and definitely am hitting the point where I have to dial back all my parameters to finish cuts without dropping steps.