No access to natural gas? I'm assuming you live too far from the gas lines to make a new gas installation possible?
That said, I had a instructor who's friend bought a house out at the beach 30 years ago. He didn't know what to do about heating.
He decided to put a large diesel tank on his property, and use that fuel to run a boiler. He installed baseboard hydronic tubing. He was very happy with the heating set up.
His previous system was electric, and his monthly bill was
outragious.(electrical rates really do vary from area to area.)
He also had an old Mercedes diesel automobile. One day he used the heating grade diesel for fuel for his Mercedees. His car ran fine. He was paying someting like 35 cents a gallon for gas. He used that car to commute for years. There are no taxes on the heating fuel, or at that time.
(That 35 cent quote is from a story told to me 20 years ago. I don't know if heating diesel was ever that cheap? I was told this story from a instructor who I don't completely trust. He tended to embellish.)
That said I always thought if I lived in an area where I couldn't use solar, or natural gas; I would definetly use a boiler, with propane, or diesel fuel? They make condensing boilers that are very efficient. I installed one and it wasen't that hard. I don't know if a condensing boiler can use diesel fuel, but I know you can use them with propane.
If you decide to do the work yourself; buy the third edition of Modern Hydronics. It's expensive, but go for it. Hole yourself up in a room for a weekend, and read that book. It's geared for large hydronic installations, but will handle residential installations fine. Hydronic heating is really under utilized, especially on the west coast. It's a great, energy efficient way to heat a home. I bought a fancy condensing boiler and happy with it, but I have a feeling I could heat a house with a water heater if your have enough baseboard, or tubing? And you live in a temperate climate?
Of course, hire a professional if funds are tight. Make sure the professional knows about boilers, and hydronic heating. A good first question for the contractor is what brand of 02 sensor he/she uses to calibrate the boiler. If he doesn't immediately come up with a answer, or looks confused--run. The second question should be "could you write down the what a primary/secondary hydronic piping configuration would look like?" Verify he knows what a primary/secondary system looks like, and why it's important.
Hydronic heating is vastly underutilized in the U.S., at least in California? I don't know why it isn't used in more situations? I guess engineers feel that if you are going to need air conditioning, why bother with it? I have heard incorporating air conditioning with hydronic heating is not that difficult? As to keeping zones at different temperatures, I did not find that to be a problem if you run your zones correctly.
(One other painful lesson I learned by relying on wood burning too long. Don't buy a cord of wood off Craigslist. I guarantee a guy will show up with less than a cord. If you are forced to use the fireplace; put a insert in.)
Diesel in the US has a red dye added if it's for agricultural use. "Detection of red-dyed fuel in the fuel system of an on-road vehicle will incur substantial penalties."
Presumably you have to piss off a cop in your diesel-powered vehicle enough for them to test your tank.
Hydronic heating is great, but I don't think it's well suited for retrofits.
I'm not very far from the gas lines, just on the wrong side of the street, and digging up the street is expensive.
Oil burning is more expensive than using a modern-day electric water heater, by the way. Oil has gone up in price and electric heaters have gotten much more efficient.
That said, I had a instructor who's friend bought a house out at the beach 30 years ago. He didn't know what to do about heating.
He decided to put a large diesel tank on his property, and use that fuel to run a boiler. He installed baseboard hydronic tubing. He was very happy with the heating set up. His previous system was electric, and his monthly bill was outragious.(electrical rates really do vary from area to area.)
He also had an old Mercedes diesel automobile. One day he used the heating grade diesel for fuel for his Mercedees. His car ran fine. He was paying someting like 35 cents a gallon for gas. He used that car to commute for years. There are no taxes on the heating fuel, or at that time.
(That 35 cent quote is from a story told to me 20 years ago. I don't know if heating diesel was ever that cheap? I was told this story from a instructor who I don't completely trust. He tended to embellish.)
That said I always thought if I lived in an area where I couldn't use solar, or natural gas; I would definetly use a boiler, with propane, or diesel fuel? They make condensing boilers that are very efficient. I installed one and it wasen't that hard. I don't know if a condensing boiler can use diesel fuel, but I know you can use them with propane.
If you decide to do the work yourself; buy the third edition of Modern Hydronics. It's expensive, but go for it. Hole yourself up in a room for a weekend, and read that book. It's geared for large hydronic installations, but will handle residential installations fine. Hydronic heating is really under utilized, especially on the west coast. It's a great, energy efficient way to heat a home. I bought a fancy condensing boiler and happy with it, but I have a feeling I could heat a house with a water heater if your have enough baseboard, or tubing? And you live in a temperate climate?
Of course, hire a professional if funds are tight. Make sure the professional knows about boilers, and hydronic heating. A good first question for the contractor is what brand of 02 sensor he/she uses to calibrate the boiler. If he doesn't immediately come up with a answer, or looks confused--run. The second question should be "could you write down the what a primary/secondary hydronic piping configuration would look like?" Verify he knows what a primary/secondary system looks like, and why it's important.
Hydronic heating is vastly underutilized in the U.S., at least in California? I don't know why it isn't used in more situations? I guess engineers feel that if you are going to need air conditioning, why bother with it? I have heard incorporating air conditioning with hydronic heating is not that difficult? As to keeping zones at different temperatures, I did not find that to be a problem if you run your zones correctly.
(One other painful lesson I learned by relying on wood burning too long. Don't buy a cord of wood off Craigslist. I guarantee a guy will show up with less than a cord. If you are forced to use the fireplace; put a insert in.)